Jul 10, 2023

Unloading Arrangement of Shaftless Screw Conveyor

Leave a message

1. Bottom unloading: used for unloading and distributing materials to hoppers, silos or stockpiles. Unload the material at any required length opening at the bottom of the conveyor helical trough. The materials are piled up to form a natural stockpile, and the materials that continue to come later are sent to the unloaded place through the stockpile.

2. Unloading at the end of the spiral trough: the material is directly discharged through the opening at the end of the screw conveyor trough. The helix is supported by partial end plates and the bearings are mounted on the end flanges. This unloading method cannot be used when the conveyor fill factor exceeds 0.45.

3. Unloading at the end: the tail section screw of the conveyor is supported by a standard suspension bearing. This form of unloading arrangement can freely unload the material to the silo or storage pile and similar places.

4. Multi-point loading: It is often required to arrange a conveyor with multi-point feeding, which is adjusted manually. When only one feed opening needs to be open at any given time, the gate or switching device should be limited in opening so as not to overload the conveyor. When it is necessary to open more than one inlet, carefully adjust and restrict the flow of each inlet so that the total amount does not exceed the design capacity of the conveyor. Controls the total material flow when multiple feed ports need to be all open to feed the conveyor at the same time.

5. Discharge port without connecting pipe: the material falls directly through an opening at the bottom of the spiral tank. Generally, it is used for unloading in the middle of the device, and there is no need to stop unloading until there is no blanking difference at this point. For example, it is used to discharge material to the warehouse.


https://www.limesilo.com/

Send Inquiry