The structure of the shaftless screw conveyor is simple. However, several problems are often encountered during the specific operation. Everything has a wear period, especially for non-standard products such as mechanical equipment. It is inevitable that you will encounter unexpected problems in use. The editor of Chunlei will give you a specific explanation, I hope it will be helpful to you:
(1) The screw shaft of the screw conveyor generally stops rotating due to three reasons;
1. The conveying material is too large, the material cannot pass the middle suspension bearing smoothly, and the material resistance at the middle bearing is too large. Causes the motor to shut down due to overload. At this time, the material in the screw conveyor must be cleaned.
2. The resistance at the middle bearing is too large and the seal is damaged. Material entering the bearing causes the bearing not to rotate or the bearing is damaged.
3. The bearing of the reducer is burnt out.
(2) The temperature of the reducer bearing rises too fast after driving, and there is abnormal noise, accompanied by the vibration of the motor and reducer. At this time, the machine should be shut down quickly and the reasons should be found in the following aspects:
1. The bearing temperature at the output shaft of the reducer is high. The temperature at the input shaft is normal. This is because the center of the screw shaft is offset or the bearing at the output shaft of the reducer is burned, and the first and end bearing seats are loose. The coupling between the output shaft of the reducer and the screw shaft needs to be loosened and re-calibrated and installed.
2. The temperature of the bearing at the output shaft of the reducer is normal, and the temperature at the input shaft is high. This is because the fixed components of the motor are loose or the bearing at the output shaft of the reducer is burned. It is necessary to loosen the coupling between the input shaft of the reducer and the motor and re-calibrate and install it.
3. The temperature at the output and input bearings of the reducer is high. This is because the fixing bolts of the reducer are loose or the bearings at both ends of the reducer are burnt. The couplings at both ends of the reducer need to be loosened and re-calibrated and installed! Tongchang is a professional manufacturer of screw conveyors and will provide you with 24-hour service.
Apr 16, 2021
Reasons For The Screw Shaft To Stop Rotating In The Shaftless Screw Conveyor
Send Inquiry
